Assigning Allowed-List Call Restrictions 5 - AT&T MERLIN 3070 Administration Manual

Assigning Allowed-List Call Restrictions
Once you have created an allowed list you can assign it to any voice terminal. Follow
the procedure below to assign allowed-list call restrictions.
1. If you have not already done so, enter administration mode by follow-
ing the boxed instructions on page 28.
2. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the
green light next to Adm Misc becomes steady.
3. Dial the 2-character code #4.
4. Dial the number of the list (0 through 7) that you want to assign or
reassign to voice terminals.
Green lights come on next to the Auto Intercom buttons for all voice ter-
minals that can access the allowed list.
When you first set up your system, no terminals are able to access any
list.
5. Touch the Auto Intercom button for each voice terminal whose status
you want to change until the correct code is showing.
Green light on = terminal can access the numbers in the list
Green light off = terminal cannot access the numbers in the list
If you don't have an Auto Intercom button for a voice terminal, perform
One of the following operations as step 5.
• To add a voice terminal, touch Hold, then dial its intercom number.
• To remove a voice terminal, touch Drop, then dial its intercom
number.
• To remove all the voice terminals from the group, touch Drop, then
touch .
When you use Hold or Drop, the console will beep if you try to add a
voice terminal that is already in the group or to remove a voice terminal
that is not in the group.
6. Repeat steps 3 through 5 for each allowed list that you want to assign
to voice terminals in your system.
7. If you have a printer, you can request a printout to make sure the ap-
propriate voice terminals have access to the allowed lists you have set
up. To get a printout, dial the 4-character code #904.
The green light next to Adm Mist flashes. When the printout is com-
pleted, you hear a beep and the green light next to Adm Mist becomes
steady
Don't go on to step 8 until you hear the beep or you'll get an incomplete
printout. Wait to remove your printout until you have completed step 8
or your page alignments will be affected.
8.Touch Adm Misc.
The lights next to the administration mode buttons flash again.
9. Continue to administer your system, or leave administration mode by
following the boxed instructions on page 28,
A printout of a typical voice terminal access list appears on the next page.
51