Assigning Personal Speed Dial Codes To 5- And 10-Button Voice Terminals And Basic Telephones 1 2 - AT&T MERLIN 3070 Administration Manual

ASSIGNING PERSONAL SPEED DIAL CODES TO 5- AND 1O-BUTTON VOICE
TERMINALS AND BASIC TELEPHONES
On 5- and 10-button voice terminals, you can program Personal Speed Dial codes
instead of Outside Auto Dial buttons for frequently used numbers. You can also give
basic telephones this capability, but only if you use Centralized Voice Terminal Pro-
gramming. Use Centralized Voice Terminal Programming or follow the procedure
below to program Personal Speed Dial codes.
1. Go to the voice terminal you want to program.
2. Slide the T/P switch on the left sid eof the voice terminal to P.
The voice terminal rings every 5 seconds to remind you it is in program mode.
3. Dial the 3-character code you want to assign to the telephone number
(available codes are #01 through #22)
4. Dial 90
5. Dial the telephone number (16-digit maximum). You can include the following
special characters: Hold (Pause) for a pause, Drop (Stop) for a stop, Transfer
for Touch-Tone Enable, and Recall for a switchhook flash.
6. Make a list of all Personal Speed Dial code numbers and the telephone
numbers they represent.
7. If you have more Personal Speed Dial numbers to assign to this voice terminal,
repeat steps 3 through 5. Otherwise, slide the T/P switch to the center
position to return to normal operation.
121