Table of Contents
Advertisement
To set the codec for a connection to another AltiServ server:
1.
Select the server in the Servers list.
2.
In the drop-down below the list, select the codec to use for a
connection to this server.
Note:
AltiServ-to-AltiServ IP connections between systems using OE
4.5 must use the same codec.
To set ranges and values for dynamic IP addressing:
1.
In the G711 IP Ranges list, click the Add button. The Add IP Codec
Setting dialog appears.
Figure 4. Add IP Codec Setting
2.
In the Add IP Codec Setting dialog, specify Single or Range to set a
single dynamic IP address or a range of addresses.
3.
Enter a Start value and, for a Range, an End value for the dynamic IP
addresses your IP extension users can access.
You cannot use the minimum and maximum values (0.0.0.0. and
255.255.255.255).
4.
Click OK.
5.
Repeat these steps for every range or value you wish to make available
for users of IP extensions with dynamic addressing.
IP and Physical Extension Login/Logoff Interaction
When an IP extension associated with a physical extension logs in, the
physical extension is disabled. When the IP extension logs off, the physical
extension is automatically enabled.
AltiWare OE System Installation & Administration Manual
Extension and Workgroup Configuration
199
Advertisement
Table of Contents
Troubleshooting
