Setting The Hp Netserver's Boot Passwords - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 10
The "System Time" field is highlighted by default when the "Configuration" menu
is selected. This field actually consists of three sub-fields, enclosed in brackets
[xx:xx:xx]: hours to the left (24-hour clock), minutes in the middle, and seconds
to the right.
4. Type in the hour and press Enter to move to the minutes' field.
5. Type in the minutes and press Enter again to move to the seconds' field.
6. Type in the seconds and press Enter, then use the arrow keys to leave this
field.
7. Use the up/down arrow keys to scroll to the System Date field and enter
the system date in the field.
The dates are entered in the "System Date" field in the same way as the time is
entered in the "System Time" field. This field also has three separate sub-fields
for month, day, and year enclosed in brackets [xx/xx/xxxx].
8. Type in the month and press Enter to move to the day field.
9. Type in the day and press Enter again to move to the year field.
10. Type in the year and press Enter, and then use the arrow keys to leave this
field.
11. Use the right-arrow or left-arrow key to select the Exit menu.
12. Choose Exit Saving Changes from the list of exit options, then press
Enter.
A dialog appears and asks you to confirm your decision.
13. Choose Yes and then press Enter.
Then the HP NetServer reboots.

Setting the HP NetServer's Boot Passwords

The HP NetServer can have separate administrator and user password. The user
password is limited in access once booted.
To configure the HP NetServer for passwords and to require a password during
boot-up, perform following procedure.
1. If not already in the Setup Utility, boot or reboot the system and press F2
when prompted.
120
Configuring the HP NetServer