HP LC2000r - NetServer - 128 MB RAM Installation Manual page 74

Chapter 6
Figure 6-5. Installing an Accessory Board
14. Lower the retainer.
15. Secure the PCI board by rotating the locking lever counter-clockwise to
hold the retainer (see Figure 6-3).
NOTE
Be sure the PCI latch and retainer close fully so that the slot
will power on when the NetServer reboots.
16. Replace the PCI front board hold down.
17. If the installed accessory board requires an external connection, or a
connection to the I/O board, ensure the cable is properly attached.
Refer to the accessory board documentation for connection requirements.
18. Follow the procedure in Chapter 3, "Opening and Closing the HP
NetServer," for closing up the server.
19. Reconnect power and cables.
20. Power on the HP NetServer according to the respective NOS power up
instructions.
66
Installing Additional Boards