HP LC2000r - NetServer - 128 MB RAM Installation Manual page 120

Chapter 10
Custom Configuration
Only select Custom if you are experienced in NetServer configuration and have a
preferred sequence of steps, or if you prefer to configure your system one
component at a time. In Custom configuration mode, you perform the same
configuration steps as provided in Express configuration mode, but these may be
done in any order.
After you have selected the NOS, NOS version, and NOS installation mode
(automated or manual), and after you have viewed the Configuration Advisories,
the Custom Configuration screen displays the following menu:
Essential Steps
Configure Remote Management:
This executes the Integrated Remote Assistant configuration utility.
Configure Disk Array:
This configures your HP disk array, but requires you to fill out the Disk
Array Configuration Worksheet, before proceeding. Click Help for more
details.
Execute Card Utilities:
This executes the available configuration utilities for installed cards.
Create Drivers Diskette(s):
SCSI IDE HP NetRAID Adapter and video adapter drivers for MS
Windows NT 4.0 on HP NetServers.
Recommended Steps
Update System BIOS:
This utility will update the system BIOS. The utility partition, if installed,
will also be updated.
Install/Update Utility Partition:
Installs utility partition to the boot or system drive. This is not available
under SCO UnixWare.
Show System Information:
Shows hardware inventory and system resource (interrupts, I/O space)
allocation.
Show NOS Installation Instructions:
Select this option to save a copy of NOS installation instructions to diskette
and to print it out.
112
Configuring the HP NetServer