HP LC2000r - NetServer - 128 MB RAM Installation Manual page 82

Chapter 7
12. Align the processor being added over the next available slot so that the
heat sink faces away from the system board for processors 1, 2, and 3, and
towards the system board for processors 4, 5, and 6.
13. Gently push down on the processor being added until it is fully seated.
14. Rotate the retaining latches to seat the processor firmly in the connector.
15. Close the access covers to the processor slots and tighten the thumbscrew
(see Figure 7-2).
16. Install the corresponding VRM by aligning the VRM with the slot. Note
that the component side of the VRM will face toward the system board.
CAUTION
Push down on the printed circuit of the VRM -- do not push
down on the VRM components.
17. Gently insert the VRM into the slot (see Figure 7-4).
74
Installing Additional Processors
Figure 7-3. Open the Latches