HP LC2000r - NetServer - 128 MB RAM Installation Manual page 55

Chapter 4
4. With the drive ejector handle open, gently slide the module into the cage.
Stop when you feel resistance.
5. For the LH 6000r, slowly close the ejector handle. Verify that the pin
behind the pivot end of the handle engages the hole in the edge of the cage.
6. For the LH 6000, verify that the locking pin behind the pivot end of the
handle engages the hole in the chassis (see Figure 4-8).
7. With even pressure, gently close the ejector handle until the locking latch
clicks shut.
NOTE
Closing the ejector handle engages the drive with the electrical
connector in the hot-swap mass storage cage and seats the
drive.
8. If the drive is unseated in the cage after closing the ejector handle, repeat
step 5.
Figure 4-8. Locking Tab Location
Installing Mass Storage Devices
47