HP LC2000r - NetServer - 128 MB RAM Installation Manual page 21

Chapter 2
Lock
Status
Screen
Escape
Table 2-1. Front Panel Console Switch and Indicator Definitions
Control
Lock (LH 6000 only)
Locked
Open
DC Power Switch
and LED
Door reveals this panel
Power Power-on
Switch LED
Reset
Enter
Figure 2-3. Front Panel Console
Description
Locks system to prevent unauthorized use.
Note that locking and unlocking of the enclosure is reported to
the system event log (SEL).
Turns the NetServer on and off. This switch is under the
protective door on the front panel. Push once to turn on, again
to turn off. As long as the AC power is connected to the
NetServer, standby power is present.
l
If the LED is steady green, then the NetServer is
powered-up.
l
If the LED is flashing green, the NetServer is in
a power-save mode.
l
If the LED is off, but the two-line display has a
message, standby power is present.
If the NetServer is set up to go into power-save mode, the
power switch is depressed; you must press it for more than four
seconds to effect a power down.
Controls, Ports, and Indicators
Secure
Mode
Reset
Switch
Switch
Secure
Mode
LED
Server
Status
LEDs
Scroll Scroll
Down Up
13