Installing Rack Nuts - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 13
Use the template to
measure, or count up
21 from baseline on inside
face for rear slide mounts.
Template
p/n
5064-5869
Baseline

Installing Rack Nuts

Rack nuts are installed on the front columns to secure the bezel latch and hinge.
Use the rack template to locate the mounting holes (see Figure 13-3).
1. Install the bezel latch rack nuts on the right front column (holes 11 and 15
counted up from the baseline).
2. Install the bezel hinge rack nuts on the left front column (holes 6 and 19
counted up from the baseline). Rack nuts are installed on the rear columns
to secure the Z-bracket, which is secured to the HP NetServer. Use the rack
template to locate the mounting holes (see Figure 13-3).
3. Install the Z-bracket rack nuts on the right rear column (holes 9 and 13
counted up from the baseline).
NOTE
The Z-bracket installation is only required if the NetServer is to
be shipped while installed in a rack. The Z-bracket allows the
NetServer to be secured to the rear rack column.
The inside face
is the one inside
the rack (at 90
degrees to you
when you
open the
rack door).
Figure 13-2. Marking the Rack Columns
Alternative Rack Mounting
The slides
fasten
behind
the outside
face of the
front of
the rack,
at the
22nd and
20th holes
above the
unit below.
151