Tools Required; Rack-Mounting Guidelines And Precautions - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 8 Installing the HP NetServer in an HP Rack System/E or Rack System/U
NOTE The pedestal HP NetServer LH 6000 cannot be rack-installed
without a conversion kit. Contact your HP reseller for
information about the HP NetServer LH 6000 to LH 6000r
Conversion Kit.

Tools Required

The following tools are required to mount the HP NetServer in the rack:
Torx 15 driver
Torx 25 driver
HP NetServer LH 6000r Rack Template
l
Tape or a marker pen to mark mounting locations

Rack-mounting Guidelines and Precautions

Observe the following guidelines and safety precautions during the rack-mount
installation.
l
Extend the rack's anti-tip foot from under the front of the rack or insure
that the anti-tip feature is installed (see Figure 8-2) prior to any work on
the rack to prevent rack tip-over, equipment damage, and injury.
WARNING Lower the leveler feet at the four corners of the rack to
improve stability and prevent the rack from rolling away as
devices are inserted into their rack mounts. Failure to use the
anti-tip foot/device and leveler feet could result in serious
injury.
l
Uneven mechanical loading within the rack can cause hazardous
conditions. Plan the placement of equipment in the rack to ensure balanced
loading.
CAUTION If other rack components are to be mounted in the rack below
the HP NetServer, install those components before starting to
mount the NetServer.
80