HP LC2000r - NetServer - 128 MB RAM Installation Manual page 73

Chapter 6
NOTE To prevent intermittent problems, ensure each unused PCI slot
has a PCI slot cover. If a PCI board is removed and not
re-installed, you must install a PCI slot cover.
CAUTION
Do not bend the PCI board to install it into the slot.
If the PCI board is full-length, the PCI front board hold-down
at the rear of the PCI slot is used to hold the board in place.
The front board hold down prevents the board from moving
during NetServer transportation and handling.
11. Before installing the PCI board:
Verify there is no handle attached to it, especially if it is a full-length
board.
If it has a handle attached, remove the handle before installing the
board into the slot.
12. Align the board with its slot, along its full length, and position it into the
slot (see Figure 6-5).
NOTE
Slots are keyed to prevent a board from going into the wrong
slot.
13. Push the PCI board down into its connector in the I/O board.
Installing Additional Boards
65