Attaching The Slides - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 13
1. Hold the bar nut behind the outside face of the front column, at the slide
screw holes marked earlier. Start (but do not tighten) two screws through
the face of the into the bar nut.
2. Install the bar nuts on both front columns.

Attaching the Slides

The following steps describe how to attach the slides to the columns.
1. Remove hex nuts and lock washers securing the removable mounting
flange to the slide. Save the hex nuts and lock washers.
2. Remove the removable mounting flange. A large flat blade screwdriver
inserted between the flange and the slide at the end of the slide may help in
removing the flange. This mounting flange is not required when installing
a slide in an HP systems rack.
3. Hold the slide so the slide members extend out the front of the rack (see
Figure 13-5).
NOTE
The slide members cannot be removed.
Place bar nut
behind outside
face of column.
Start two screws
in bar nut but do
not tighten.
Figure 13-4. Installing Bar Nuts
Alternative Rack Mounting
153