HP LC2000r - NetServer - 128 MB RAM Installation Manual page 152

Chapter 12
Refer to Figure 12-1 and the Technical Reference Card inside the top cover.
CPU Speed
CPU Speed
CPU Speed
Clear Config
Clear Password
Not Used
Figure 12-1. System Board Assembly and Configuration Switch
5. Move the configuration memory switch, switch 5 on the system board, to
the "ON = CLEAR CONFIG" position.
6. Plug in the power cords, and turn on power to the HP NetServer. The
following message appears:
The configuration has been cleared. Set the
Clear Config switch to the OFF position
before rebooting.
7. Turn off power to the HP NetServer and unplug the power cords.
8. Return switch 5 on the system board to the OFF position.
9. Follow the procedure in Chapter 3, "Opening and Closing the HP
NetServer," for closing up the server.
10. Reconnect power and cables.
11. Restore HP NetServer to normal operation.
144
Troubleshooting