HP LC2000r - NetServer - 128 MB RAM Installation Manual page 54

Chapter 4
3. Open the drive module by pressing in on the locking latch at the end of the
drive ejector handle and pulling open the handle.
CAUTION
Be careful when you open the ejector handle. Extreme force
can snap off the handle. Be careful not to damage the light
pipes as you insert the drive. They are very fragile.
Locking tab
pivots when
the ejector
handle is open.
Drive ejector
handle
Figure 4-7. Readying Drive for Installation
46
Figure 4-6. Removing the Drive Spacer
Locking Latch
Installing Mass Storage Devices
Drive
Spacer
Light Pipes
(fragile)