If The System Does Not Power On; If The System Powers On, But Fails Post - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 12
Mouse
1 hard disk drive and 1 flexible disk drive
1 CD-ROM
d. Remove all third-party options, and reinstall each one, one at a time,
checking the NetServer after each installation.
e. Replace the top cover and reconnect the power cords and other cables.
f. Start the NetServer and, if it does not function properly, refer to the
following procedures.

If the System Does Not Power On

Follow these steps:
1. Check that all cables and power cords are firmly plugged into their proper
receptacles.
2. Check that all parts of the system are turned on and properly adjusted.
3. Verify that the power source is providing the correct voltage and current.
4. If the server is plugged into a switched multiple-outlet box, make sure the
switch on the outlet box is turned on.
5. Plug a different electrical device (such as a printer) into the power outlet,
and turn it on.
6. Unplug the power cords, wait 20 seconds, plug the power cords in again,
and restart the system.

If the System Powers On, but Fails POST

Do one of the following:
If the system gives a series of beeps, this indicates a system error. Contact
HP or your reseller.
If the system fails POST and an error message appears, refer to the section
"Error Messages." If the suggested solutions do not solve the problem,
contact HP or your reseller.
140
Troubleshooting