HP LC2000r - NetServer - 128 MB RAM Installation Manual page 119

Chapter 10
Select View Hardware Inventory on the Show System Information
screen to display information about standard and accessory boards and
devices in the system.
Select View Resources on the Show System Information screen to
display used and available system resources such as memory ranges,
I/O port ranges, DMA channels, and interrupt (IRQ) levels.
Configure Disk Array:
This configures your HP disk array. Refer to the Integrated HP NetRAID
Controller Configuration Guide.
NOTE
When you configure an array, the default cache mode is
write-through. For write-back mode, install the optional battery
back-up accessory.
Install Utility Partition:
This step creates an 32 MB DOS-based utility partition on the NetServer
hard disk where HP Navigator will copy DiagTools, the BIOS Update
utility, the Event Log Report utility, the Disk Array utility, the NIC
Configuration utility, the Integrated Remote Assistant utilities,
troubleshooting utilities, and other utilities. A Utility Partition is not
available for SCO UnixWare.
Select Execute on the Install Utility Partition screen.
Execute Card Utilities:
Use this function, when Configuration Assistant detects installed boards,
which have additional configuration utilities on the HP NetServer
Navigator CD-ROM. By selecting Execute on the Execute Board Utilities
screen, you can execute these utilities to complete the configuration of the
boards.
Configuring the HP NetServer
111