HP LC2000r - NetServer - 128 MB RAM Installation Manual page 22

Chapter 2
Control
RESET
Secure Mode Switch
and Indicator
Status screen
Server Status LEDs
Red
Yellow
Green
Red Yellow Green
Off Off Off
Flashing Off Off
Off Flashing Off
Off Off On
14
Description
Resets the NetServer. This switch may be disabled by Secure
mode.
Locks system keyboard, monitor display, and control panel to
prevent unauthorized use. Go to the Setup utility security menu
to configure this feature. Secure Mode LED illuminates when
Secure Mode is enabled.
Reports system status. For details, see the following section:
"Viewing System Information."
Three LEDs -- one red, one yellow, one green -- are on the
right side of the front panel console. They give you a quick
idea of the NetServer's general health. The signals provided
reflect the most critical pending event in the system.
Indicates NetServer Status:
Main power is off and the NetServer may or may not
be on standby power.
Immediate attention required due to a failed
component in the NetServer. The NetServer may not
be fully operational due to this condition. An audible
alarm may also be enabled.
Attention required due to a pre-failure condition. This
condition may be caused by a component failure (for
example, a redundant fan or power supply) or an open
access panel that could lead to a critical component
failure, such as a processor module exceeding its
operating temperature. If the failed component is
redundant, the NetServer may still be operating
normally. An audible alarm may also be enabled.
The NetServer is operating normally.
Controls, Ports, and Indicators