Installing The Hba Driver On Your Netware Servers - HP StorageWorks Modular Smart Array 1500 cs Installation Manual

Configuration Procedures - NetWare Environments

Installing the HBA Driver on your NetWare servers

1. Install the HBA(s), power on the server, and start your NetWare operating
2. Insert the MSA1500 cs Support Software CD into the CD-ROM drive.
3. From the system console, mount the CD-ROM drive and enter the following:
4. Follow the onscreen instructions to complete the driver installation.
5. After the driver is installed, load the NWCONFIG utility by entering:
6. Select Edit STARTUP.NCF file and press Enter.
7. At Specify a server boot path: enter the path.
8. Enter the following Load command for each HBA, using the appropriate slot
9. Press F10 to save these changes and then return through all previous menus.
10. Remove the MSA1500 cs Support Software CD from the CD-ROM drive and
11. Repeat these procedures for each NetWare server with access to the
74
Caution: You must use the MSA1500 cs Support Software CD to install the
driver for the HBA on the server. Drivers for all supported HBAs are included
on the CD and are the only versions approved for use with the MSA1500 cs.
Do not obtain or use an HBA driver from the HBA manufacturer or the
MSA1000 web site.
system.
HPSSCDxxx:\netware\hpsetup.nlm
(HPSSCDxxx is the label of the MSA1500 cs Support Software CD.)
The driver installation screen is displayed.
NWCONFIG
In the Configuration Options screen, select NCF files Options. Press Enter.
The default path is
C:\NWSERVER.
number to indicate where the HBAs are inserted in the server:
LOAD QL2300.HAM SLOT = xx /LUNS /ALLPATHS /PORTNAMES
(xx represents the slot number.)
restart your NetWare server to load the new drivers.
MSA1500 cs.
Modular Smart Array 1500 cs Installation Guide