Clearing The Cmos Configuration - HP Netserver LP2000r Service Manual

Chapter 4
Remove and reinsert the processor(s) firmly in the sockets on the system board.
◊ ◊ ◊ ◊
Remove and reinsert the DIMMs firmly and correctly in the slots.
◊ ◊ ◊ ◊

Clearing the CMOS Configuration

You may need to clear the CMOS configuration if the configuration has been corrupted, or if incorrect
settings made in the Setup Utility have caused error messages to be unreadable.
To clear the configuration:
1. Turn off power to the Netserver and remove the cover.
2. Move switch 4 in the configuration switch on the system board (labeled "Clear CMOS") to the
ON position.
3. Turn on power to the Netserver.
A message displays indicating the configuration has been cleared.
4. Turn off power to the Netserver.
5. Return switch 4 on the system board to the OFF position.
6. Replace the cover.
7. Turn on power to the Netserver and the following message displays:
Incorrect System Configuration
8. Press [F2] to run the Setup Utility when <F2=Setup> appears.
9. Make any configuration changes required.
10. Choose the Exit option and save the changes to save the configuration and exit the Setup
Utility.
Switch 1 Position
Spring Latch
Configuration Switch Location
Configuration Switch
Battery
Diagnostics
41