Tools Required; Hp Netserver Rack Mount Parts List - HP D5970A - NetServer - LCII Installation Manual

Chapter 13
room's ambient temperature. Make sure that the temperature within the
rack itself does not exceed 35 C.
Reduced Air Flow. As you mount equipment in the rack, make sure that
you allow enough air flow for safe operation of the equipment.
Mechanical Loading. Uneven mechanical loading within the rack can
cause hazardous conditions. Plan the placement of equipment in the rack
to make sure that this problem does not occur. Mount the heaviest
components in the bottom of the rack, and mount all components as low
in the rack as is practical.
Circuit Overloading. Make sure that t he total configuration of
equipment in the rack does not overload the supply circuit. To this end,
check the nameplate ratings on all equipment. Consider the effect of
circuit overloading on overcurrent protection and supply wiring.
Reliable Earthing (Grounding). Maintain reliable earthing of
rackmounted equipment. Give particular attention to supply connections
that are not direct connections to the branch circuit: the use of power
strips, for example.

Tools Required

You need these tools to mount the HP NetServer in the rack:
Nut driver or wrench
T-15 and T-25 Torx Drivers
Number 2 Phillips screwdriver
Marking pen

HP NetServer Rack Mount Parts List

Makes sure that the rack-mount kit that accompanies the HP NetServer contains
the following parts:
Table 13-1. Parts for Rack Mount Kit
Quantity
2 Slides
4 Rack Nuts
Description
Alternative Rack Mounting
117