HP D5970A - NetServer - LCII Installation Manual page 44

Chapter 5
Key:
Figure 5-3. DIMM Slot Numbers and Bank Numbers
Please note the following DIMM installation guidelines before adding memory:
Add (or remove) DIMMs to the memory board in groups of four .
Each group of four DIMMs must fill one bank on a memory board. A
bank must be either fully populated or completely empty. See Figure 5-3.
When populating a memory board, fill Bank A first, then Bank B,
then Bank C, and finally Bank D. You must do this if a board is to have
four-way interleaving.
36
Installing Additional Memory
Bank A (Slots J1, J2, J3, J4)
Bank B (Slots J5, J6, J7, J8)
Bank C (Slots J9, J10, J11, J12)
Bank D (Slots J13, J14, J15, J16)
J1
J2
J5
J6
J9
J10
J13
J14
J3
J4
J7
J8
J11
J12
J15
J16