HP D5970A - NetServer - LCII Installation Manual page 133

Chapter 13
3. With the help of at least one other person, lift the server by its four
handles. Move the server between the extended slide members, so that the
slides are underneath the server's handles on each side. See Figure 13-8.
2. Fasten server
to slides with
screws
Figure 13-8. Mounting the Server on the Slides
4. Lower the server onto the slide members. The server's handles will
support the server on the slides for now. Adjust the server's position on the
slides so that the mounting holes on the side of the chassis line up with
the screw holes in the slide members.
5. Fasten the server to the slides with screws.
6. Remove the screws that attach the handles to the server. (See Figure
13-9). Take the handles off the server. Store the handles and screws in a
convenient place. Reattach the handles whenever you remove the server
from the rack. (If you plan on shipping the server elsewhere, always pack
it with the handles attached.)
Alternative Rack Mounting
1. Move server onto slides
125