Step 4: Attaching The Front Bezel - HP D5970A - NetServer - LCII Installation Manual

Chapter 13

Step 4: Attaching the Front Bezel

The front bezel is attached to the server by a hinge and a latch. You must attach
the hinge and latch to the front of the server before mounting the bezel.
1. Push the hinge into place on the left edge of the front of the HP NetServer.
The two hooks on the rear of the hinge must fit into the two matching
holes on the front of the server. The hooks attach the hinge to the server,
but not securely. See Figure 13-11.
1. Push hinge
against front
of server
Figure 13-11. Pressing the Bezel Hinge onto the Front of the HP NetServer
128
2. Insert hooks into
matching holes
on front of server
3. Swing hinge open
Alternative Rack Mounting
(to the left)