Re-Enabling A Disabled Processor; Scsi Configuration Utility - HP D5970A - NetServer - LCII Installation Manual

Chapter 10
5. Press F10 to save the configuration changes and exit. The server reboots.

Re-enabling a Disabled Processor

If a processor is disabled during the HP NetServer's power-on self-test (POST),
you can re-enable it through the setup utility:
1. Start the setup utility.
2. Use the right-arr ow of left-arrow key to go to the Server menu. Once
there, use the down-arrow key to go to the Server Processor
Retest field. Choose Yes.
3. Press F10 to save the configuration changes and exit. The server reboots.

SCSI Configuration Utility

The HP NetServer LXr 8000 has a SCSI configuration utility in read-only
memory. Use this utility to add or remove the HP NetServer's two built-in SCSI
channels from the server's boot order. You can also configure individual
channels, and the individual devices controlled by those channels.
To reach the SCSI configuration utility:
1. Boot or reboot the HP NetServer
As usual, start-up messages inform you that memory, the keyboard, and
the mouse have been initialized. This message appears.
Press CTRL-C to start Symbios Configuration
Utility
2. Press CTRL-C within five seconds. The configuration utility's main screen
appears.
For more on this utility, refer to the Information Assistant application on the HP
NetServer Online Documentation CD-ROM. Information Assistant contains the
entire set of documentation for your NetServer.
Configuring the System
103