HP D5970A - NetServer - LCII Installation Manual page 10

Chapter 1
4. If you have options to add to the HP NetServer (memory, accessory
boards, processor boards), remove the appropriate access panels from the
computer. Refer to Chapter 3.
5. Install additional processors and voltage regulator modules, if desired.
Refer to Chapter 7.
6. Install additional memory. Refer to Chapter 5.
7. Install PCI and PCI Hot Plug accessory boards. Refer to Chapter 6.
8. Reconnect all internal cables and reattach all covers and access panels.
Refer to Chapter 3.
9. Install disk drives or tape drives. Refer to Chapter 4.
10. Familiarize yourself with the HP NetServer's controls, indicators, and
ports. Refer to Chapter 2.
11. Your next step depends on when and where you plan to complete the
installation process.
Do you plan to install the HP NetServer in a rack now? If so, install
the HP NetServer in the rack. (Refer to Chapter 8.) Cable the monitor,
keyboard, and mouse to the HP NetServer (Refer to Chapter 7), and
also connect mass storage, tape drives, and other components.
Do you plan to complete the configuration at another location? If so,
put the HP NetServer back in the packing box, finish repacking, and
ship the unit out.
Do you plan to configure and test the HP NetServer and other
components together before mounting them in the rack? If so, cable
the monitor, keyboard, and mouse (Refer to Chapter 8) to the HP
NetServer. Also connect mass storage, tape drives, and other
components.
12. Obtain the release history of the HP NetServer Navigator CD-ROM that
came with your HP NetServer, to make sure that your Navigator CD-ROM
is the latest. Refer to Chapter 10.
13. Power up the HP NetServer. Refer to Chapter 2.
14. Insert the Navigator CD-ROM, reboot, and check the Navigator
README file for important installation information. Refer to
Chapter 10.
2
Setting Up the HP NetServer LXr 8000