HP D5970A - NetServer - LCII Installation Manual page 75

Chapter 7
Table 7-1. Processor Baseboard Configurations for 1 Through 4 Processors
Number of Install Processor
Processors in These Slots
1
2
3
4
2. Log off all users. Back-up files. Follow instructions in your network
operating system (NOS) documentation to gracefully shut down all
networking software and applications.
3. Press the power switch on the HP NetServer's control panel when
prompted by the operating system. Normally, this is the complete
procedure.
NOTE The power supplies will continue to provide standby current to
the NetServer until the power cable is disconnected.
4. Disconnect the power cord and signal cables, and if necessary, label them
to support reassembly.
Terminators
Required for
These Slots
Proc 1 Proc 2
Proc 3
Proc 4
Proc 1 Proc 3
Proc 2 Proc 4
Proc 1 Proc 4
Proc 2
Proc 3
Proc 1 None
Proc 2
Proc 3
Proc 4
Installing Additional Processors
Voltage Regulator
Modules Required
in These Slots
VRM 1 (Cache 1/2)
VRM 2 (Cache 3/4)
VRM 3 (Core 1)
VRM 1 (Cache 1/2)
VRM 2 (Cache 3/4)
VRM 3 (Core 1)
VRM 4 (Core 2)
VRM 1 (Cache 1/2)
VRM 2 (Cache 3/4)
VRM 3 (Core 1)
VRM 4 (Core 2)
VRM 5 (Core 3)
VRM 1 (Cache 1/2)
VRM 2 (Cache 3/4)
VRM 3 (Core 1)
VRM 4 (Core 2)
VRM 5 (Core 3)
VRM 6 (Core 4)
67