Installing The Bluetooth Board - Toshiba Portege M100 Maintenance Manual

4 Replacement Procedures
4. Disconnect the antenna coaxial cable from the Bluetooth board using a tool to
disconnect an antenna coaxial cable.

Installing the Bluetooth Board

To install the Bluetooth board, make sure that the computer is in boot mode and powered off,
follow the steps below and refer to figures 4-23.
CAUTION: Be sure to switch the computer off before removing the Bluetooth board.
Otherwise, the computer or the Bluetooth board may be damaged.
1. Connect the antenna coaxial cable to the connector on the Bluetooth board.
CAUTION: Lay down the bluetooth antenna cable referring the following figure not to
be pinched.
2. Connect the one side of bluetooth flexible flat cable to the Bluetooth board.
3. Fix the bluetooth board on the system board with two M2x3 silver flat head screws .
4. Connect the other side of bluetooth flexible flat cable to the connector PJ3110 on the
system board.
4-44
Figure 4-23 Removing the Bluetooth board
PORTEGE M100 Maintenance Manual (960-452)
4.9 Bluetooth Board