Dvd-Rom Drive; Dvd-Rom Drive Troubleshooting; Procedure 1 Diagnostic Test Program Execution Check; Procedure 2 Connector Check And Replacement Check - Toshiba Portege M100 Maintenance Manual

2 Troubleshooting Procedures
2.9

DVD-ROM Drive Troubleshooting

This section describes how to if the DVD-ROM drive in the Slim Select Bay is functioning
properly. Perform the steps below starting with Procedure 1 and continue with the other
procedures as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
The CD-ROM/DVD-ROM test program is stored in the Diagnostics Disk.
Then insert the Diagnostics Disk in the computer's floppy disk drive, turn on the computer
and run the test. Refer to Chapter 3, Tests and Diagnostics, for more information about the
diagnostics test procedures.
If any errors occur while executing the CD-ROM/DVD-ROM test, go to Procedure 2.
2-42
2.9 CD-R/RW Drive Troubleshooting
PORTEGE M100 Maintenance Manual (960-452)