Executing The Diagnostic Test - Toshiba Portege M100 Maintenance Manual

3.2 Executing the Diagnostic Test

3. Select the test you want to execute and press Enter. When SYSTEM TEST is selected,
the following message will appear:
SYSTEM TEST
SUB-TEST
PASS COUNT : XXXXX
WRITE DATA : XX
ADDRESS
SUB-TEST MENU :
01 - ROM checksum
02 -
03 -
04 - Fan ON/OFF
05 –
06 - Quick charge
07 - DMI read
08 - DMI write
09 -
10 – Temperature surveillance test
11 – BT/W-LAN switch test
12 – Battery F/W test
13 – Option battery F/W test
99 - Exit to DIAGNOSTIC TEST MENU
NOTE: The menu displayed by your computer may be slightly different from the one
shown above.
4. Select the desired subtest number from the subtest menu and press Enter. The following
message will appear:
TEST LOOP : YES/NO
Selecting YES increases the pass counter by one, each time the test cycle ends and
restarts the test cycle.
Selecting NO returns the subtest menu to the main menu after the test is complete.
PORTEGE M100 Maintenance Manual (960-452)
XXXXXXX
: XX
ERROR COUNT
READ DATA
: XXXXXX STATUS
3 Tests and Diagnostics
xxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] ; test end
[Ctrl]+[C]
: XXXXX
: XX
: XXX
: Select items
Enter : Specify
Esc : Exit
; key stop
3-5