4.9 Bluetooth Board
4.9
Bluetooth Board
Removing the Bluetooth Board
To remove the Bluetooth board make sure the computer is in boot mode and powered off, follow
the steps below and refer to figures 4-23.
CAUTION: Do not try to remove the Bluetooth board with the computer turned on. You
can damage the computer and the Bluetooth Board.
1. Disconnect the Bluetooth flexible flat cable from the connector PJ3110 on the system
board.
2. Remove two M2x3 silver flat head screws and the Bluetooth board.
3. Disconnect the Bluetooth flexible flat cable from the Bluetooth board.
CAUTION: Do not touch the connectors on the Bluetooth. Debris on the connectors
may cause access problems.
PORTEGE M100 Maintenance Manual (960-452)
4 Replacement Procedures
4-43