4 Replacement Procedures
Installing the LCD/LED cable
To install the LCD/LED cable, follow the steps below and refer to figures 4-47 to 4-50.
CAUTION: Do not bend or scrub the LCD/LED cable. A slight damage may cause break
down of it. Be careful not to damage it.
1. Route the LCD/LED cable through the display hinge and seat the plastic brace.
2. Seat the LED board in the display panel.
3. Seat the display hinge in the display panel.
4. Seat the plastic brace and secure it with one M2 3 silver flat-head screw.
CAUTION: When seating the plastic brace, make sure the LCD/LED cable, wireless LAN
antenna and bluetooth antenna are not pinched. Be careful not to damage
them.
5. Secure the display hinge with two M2.5 4 black screws .
4-76
PORTEGE M100 Maintenance Manual (960-452)
4.21 LCD/LED Cable