Toshiba Portege M100 Maintenance Manual page 85

2.9 CD-R/RW Drive Troubleshooting
Procedure 2 Connector Check and Replacement Check
The DVD-ROM drive is connected to the system board. The connectors may be disconnected
from the system board or may be damaged. Disassemble the computer following the steps
described in Chapter 4, Replacement Procedures, and perform the following checks:
Check 1 Make sure the DVD-ROM drive is firmly connected to the system board.
If the connection is loose, reconnect firmly and repeat Procedure 1. If there is still
an error, go to Check 2.
Check 2 The DVD-ROM drive may be defective or damaged. Replace the drive with a
new one. If there is still an error, go to Check 3.
Check 3 Replace the system board with a new one following the steps in Chapter 4,
Replacement Procedures.
PORTEGE M100 Maintenance Manual (960-452)
2 Troubleshooting Procedures
2-43