4.15 System Board
4.15 System Board
Removing the System Board
To remove the system board, follow the steps below and refer to figures 4-35 and 4-36.
1. Remove two M2 4 screws securing the system board.
2. Remove the glass tape s securing the MDC cable and Modem/LAN cable.
3. Disconnect the MDC cable from the connector PJ3022 on the system board.
4. Disconnect the Modem/LAN cable from PJ3021 and PJ4101 on the system board.
Figure 4-35 Removing the screws securing the system board
PORTEGE M100 Maintenance Manual (960-452)
4 Replacement Procedures
4-55