Configuring Ipv4 Multicast Layer 3 Switching; Understanding How Ipv4 Multicast Layer 3 Switching Works - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Configuring IPv4 Multicast Layer 3 Switching

This chapter describes how to configure IPv4 multicast Layer 3 switching on the Catalyst 6500 series
switches.
For complete syntax and usage information for the commands used in this chapter, refer to these
Note
publications:
•
•
This chapter consists of these sections:
•
•
•
•
•
•

Understanding How IPv4 Multicast Layer 3 Switching Works

These sections describe how IPv4 multicast Layer 3 switching works:
•
•
•
•
•
OL-11439-03
The Catalyst Supervisor Engine 32 PISA Cisco IOS Command Reference, Release 12.2ZY, at
this URL:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2ZY/command/reference/cmdr
ef.html
The Release 12.2 publications at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_installation_and_configuratio
n_guides_list.html
Understanding How IPv4 Multicast Layer 3 Switching Works, page 25-1
Understanding How IPv4 Bidirectional PIM Works, page 25-6
Default IPv4 Multicast Layer 3 Switching Configuration, page 25-6
IPv4 Multicast Layer 3 Switching Configuration Guidelines and Restrictions, page 25-7
Configuring IPv4 Multicast Layer 3 Switching, page 25-8
Configuring IPv4 Bidirectional PIM, page 25-18
IPv4 Multicast Layer 3 Switching Overview, page 25-2
Multicast Layer 3 Switching Cache, page 25-2
Layer 3-Switched Multicast Packet Rewrite, page 25-3
Partially and Completely Switched Flows, page 25-3
Non-RPF Traffic Processing, page 25-5
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
25
C H A P T E R
25-1