Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 385

Software configuration guide
Hide thumbs Also See for WS-SUP32-GE-3B - Supervisor Engine 32:
Table of Contents

Advertisement

Chapter 25
Configuring IPv4 Multicast Layer 3 Switching
This example shows how to display the IP multicast Layer 3 switching configuration of interface
VLAN 10:
Router# show ip interface vlan 10
Vlan10 is up, line protocol is up
Internet address is 10.0.0.6/8
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Multicast reserved groups joined: 224.0.0.1 224.0.0.2 224.0.0.13 224.0.0.10
Outgoing access list is not set
Inbound
Proxy ARP is enabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are never sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is disabled
IP CEF switching is enabled
IP Fast switching turbo vector
IP Normal CEF switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Probe proxy name replies are disabled
Policy routing is disabled
Network address translation is disabled
WCCP Redirect outbound is disabled
WCCP Redirect exclude is disabled
BGP Policy Mapping is disabled
IP multicast multilayer switching is enabled
IP mls switching is enabled
Router#
This example shows how to display the IP multicast Layer 3 switching configuration of Gigabit Ethernet
interface 1/2:
Router# show interfaces gigabitEthernet 1/2
GigabitEthernet1/2 is up, line protocol is up (connected)
Hardware is C6k 1000Mb 802.3, address is 0001.c9db.2441 (bia 0001.c9db.2441)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Last clearing of "show interface" counters 00:05:13
....
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 10000 bits/sec, 1 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
OL-11439-03
access list is not set
284 packets input, 113104 bytes, 0 no buffer
Received 284 broadcasts (284 multicast)
0 runts, 41 giants, 0 throttles
41 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
198 packets output, 14732 bytes, 0 underruns
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Configuring IPv4 Multicast Layer 3 Switching
25-15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst supervisor engine 32 pisa

Table of Contents