Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 155

Chapter 10 Configuring EtherChannels
This example shows how to verify the configuration of Fast Ethernet port 5/6:
Router# show running-config interface fastethernet 5/6
Building configuration...
Current configuration:
!
interface FastEthernet5/6
no ip address
switchport
switchport access vlan 10
switchport mode access
channel-group 2 mode desirable
end
Router# show interfaces fastethernet 5/6 etherchannel
Port state
Channel group = 12
Port-channel
2
Port index
Flags:
Timers: H - Hello timer is running.
Local information:
Port
Fa5/2
Age of the port in the current state: 04d:18h:57m:19s
This example shows how to verify the configuration of port channel interface 2 after the LAN ports have
been configured:
Router# show etherchannel 12 port-channel
Port-channel: Po12
------------
Age of the Port-channel
Logical slot/port
GC
Port state
Protocol
Router#
OL-11439-03
= Down Not-in-Bndl
Mode = Desirable-Sl
= null GC
= 0 Load = 0x00
S - Device is sending Slow hello.
A - Device is in Auto mode.
d - PAgP is down.
S - Switching timer is running.
Flags State Timers
d U1/S1
Port-channels in the group:
----------------------
= 04d:18h:58m:50s
= 14/1
= 0x00000000
= Port-channel Ag-Not-Inuse
= PAgP
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Gcchange = 0
= 0x00000000
Protocol =
C - Device is in Consistent state.
P - Device learns on physical port.
Q - Quit timer is running.
I - Interface timer is running.
Hello Partner PAgP
Interval Count Priority
1s 0 128
Number of ports = 0
HotStandBy port = null
Configuring EtherChannels
Pseudo port-channel = Po1
PAgP
Learning Group
Method Ifindex
Any 0
10-9