Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 776

Configuring NetFlow
Other events might cause MLS entries to be purged, such as routing changes or a change in link state.
If the number of MLS entries exceeds the recommended utilization (see the
Note
Guidelines and Restrictions" section on page
flows.
To keep the NetFlow table size below the recommended utilization, enable the following parameters
when using the mls aging command:
•
•
•
A typical table entry that is removed by fast aging is the entry for flows to and from a Domain Name
Server (DNS) or TFTP server.
If you need to enable MLS fast aging time, initially set the value to 128 seconds. If the size of the
NetFlow table continues to grow over the recommended utilization, decrease the setting until the table
size stays below the recommended utilization. If the table continues to grow over the recommended
utilization, decrease the normal MLS aging time.
To configure the MLS aging time, perform this task:
Command
Router(config)# mls aging {fast [threshold {1-128} |
time {1-128}] | long 64-1920 | normal 32-4092}
Router(config)# no mls aging fast
Router(config)# no mls aging {long | normal}
This example displays how to configure the MLS aging time:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# mls aging fast threshold 64 time 30
To display the MLS aging-time configuration, perform this task:
Command
Router# show mls netflow aging
This example shows how to display the MLS aging-time configuration:
Router# show mls netflow aging
enable timeout packet threshold
------ ------- ----------------
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
47-8
normal—Configures an inactivity timer. If no packets are received on a flow within the duration of
the timer, the flow entry is deleted from the table.
fast aging—Configures an efficient process to age out entries created for flows that only switch a
few packets, and then are never used again. The fast aging parameter uses the time keyword value
to check if at least the threshold keyword value of packets have been switched for each flow. If a
flow has not switched the threshold number of packets during the time interval, then the entry is aged
out.
long—Configures entries for deletion that have been active for the specified value even if the entry
is still in use. Long aging is used to prevent counter wraparound, which can cause inaccurate
statistics.
47-5), only adjacency statistics might be available for some
Purpose
Configures the MLS aging time for a NetFlow table entry.
Disables fast aging.
Reverts to the default MLS aging time.
End with CNTL/Z.
Purpose
Displays the MLS aging-time configuration.
Chapter 47 Configuring NetFlow
"NetFlow Configuration
OL-11439-03