Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 589

Chapter 38 Configuring PFC QoS
This example shows how to configure VLAN interface 4018 for protocol-independent MAC ACL
filtering and how to verify the configuration:
Router(config)# interface vlan 4018
Router(config-if)# mac packet-classify
Router(config-if)# end
Router# show running-config interface vlan 4018 | begin 4018
interface Vlan4018
mtu 9216
ipv6 enable
mac packet-classify
end
This example shows how to configure Gigabit Ethernet interface 6/1 for protocol-independent MAC
ACL filtering and how to verify the configuration:
Router(config)# interface gigabitethernet 6/1
Router(config-if)# mac packet-classify
Router(config-if)# end
Router# show running-config interface gigabitethernet 6/1 | begin 6/1
interface GigabitEthernet6/1
mtu 9216
no ip address
mac packet-classify
mpls l2transport route 4.4.4.4 4094
end
This example shows how to configure Gigabit Ethernet interface 3/24, subinterface 4000, for
protocol-independent MAC ACL filtering and how to verify the configuration:
Router(config)# interface gigabitethernet 3/24.4000
Router(config-if)# mac packet-classify
Router(config-if)# end
Router# show running-config interface gigabitethernet 3/24.4000 | begin 3/24.4000
interface GigabitEthernet3/24.4000
encapsulation dot1Q 4000
mac packet-classify
mpls l2transport route 4.4.4.4 4000
end
Enabling VLAN-Based MAC QoS Filtering
You can globally enable or disable VLAN-based QoS filtering in MAC ACLs. VLAN-based QoS
filtering in MAC ACLs is disabled by default.
To enable VLAN-based QoS filtering in MAC ACLs, perform this task:
Command
Router(config)# mac packet-classify use vlan
To disable VLAN-based QoS filtering in MAC ACLs, perform this task:
Command
Router(config)# no mac packet-classify use vlan
OL-11439-03
Purpose
Enables VLAN-based QoS filtering in MAC ACLs.
Purpose
Disables VLAN-based QoS filtering in MAC ACLs.
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Configuring PFC QoS
38-55