Configuring Multiprotocol Label Switching; Mpls Label Switching - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Configuring Multiprotocol Label Switching

This chapter describes how to configure Multiprotocol Label Switching (MPLS) on a Catalyst 6500
series switch.
For complete syntax and usage information for the commands used in this chapter, refer to these
Note
publications:
•
•
This chapter consists of these sections:
•
•
•

MPLS Label Switching

These sections describe MPLS label switching:
•
•
•
•
•
•
•
•
OL-11439-03
The Catalyst Supervisor Engine 32 PISA Cisco IOS Command Reference, Release 12.2ZY, at
this URL:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2ZY/command/reference/cmdr
ef.html
The Release 12.2 publications at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_installation_and_configuratio
n_guides_list.html
MPLS Label Switching, page 21-1
VPN Switching, page 21-9
Any Transport over MPLS, page 21-13
Understanding MPLS, page 21-2
Understanding MPLS Label Switching, page 21-2
Supported Hardware Features, page 21-4
Supported Cisco IOS Features, page 21-5
MPLS Guidelines and Restrictions, page 21-7
Configuring MPLS, page 21-7
MPLS Per-Label Load Balancing, page 21-7
MPLS Configuration Examples, page 21-8
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
21
C H A P T E R
21-1