Configuring Other Protocols On Layer 3 Interfaces - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Configuring Other Protocols on Layer 3 Interfaces

To configure routing for AppleTalk, perform this task beginning in global configuration mode:
Command
Step 1
Router(config)# appletalk routing
Step 2
Router(config)# interface {vlan vlan_ID} |
1
{type slot/port} | {port-channel
port_channel_number}
Step 3
Router(config-if)# appletalk cable-range
cable_range
Step 4
Router(config-if)# appletalk zone zone_name
Step 5
Router(config-if)# no shutdown
Step 6
Router(config-if)# end
Step 7
Router# show interfaces [{vlan vlan_ID} |
1
{type slot/port} | {port-channel
port_channel_number}]
Router# show appletalk interfaces [{vlan vlan_ID}
1
| {type slot/port} | {port-channel
port_channel_number}]
Router# show running-config interfaces [{vlan
vlan_ID} | {type
port_channel_number}]
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet, or ge-wan
This example shows how to enable AppleTalk routing and assign an AppleTalk cable-range and zone
name to interface VLAN 100:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# appletalk routing
Router(config)# interface vlan 100
Router(config-if)# appletalk cable-range 100-100
Router(config-if)# appletalk zone Engineering
Router(config-if)# no shutdown
Router(config-if)# end
Router# copy running-config startup-config
Configuring Other Protocols on Layer 3 Interfaces
Refer to these publications for information about configuring other protocols on Layer 3 interfaces:
•
•
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
19-8
1
slot/port} | {port-channel
Cisco IOS Apollo Domain, VINES, DECnet, ISO CLNS, and XNS Configuration Guide,
Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/apollo/configuration/guide/fapolo_c.html
Cisco IOS Apollo Domain, VINES, DECnet, ISO CLNS, and XNS Command Reference,
Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/apollo/command/reference/fapolo_r.html
Chapter 19
Purpose
Enables AppleTalk routing.
Selects an interface to configure.
Assigns a cable range to the interface.
Assigns a zone name to the interface.
Enables the interface.
Exits configuration mode.
Verifies the configuration.
End with CNTL/Z.
Configuring Layer 3 Interfaces
OL-11439-03