Chapter 24
Configuring IPv6 Multicast PFC3B Layer 3 Switching
New or Changed IPv6 Multicast Commands
Refer to the Catalyst Supervisor Engine 32 PISA Cisco IOS Command Reference, Release 12.2ZY for
information about these IPv6 multicast commands:
•
•
•
•
•
•
Configuring IPv6 Multicast Layer 3 Switching
To configure IPv6 multicast Layer 3 switching, perform this task:
Command
Step 1
Router(config)# ipv6 unicast-routing
Step 2
Router(config)# ipv6 multicast-routing
Step 3
Router(config)# ipv6 mfib hardware-switching
Using show Commands to Verify IPv6 Multicast Layer 3 Switching
These sections describe how to use show commands to verify IPv6 multicast Layer 3 switching:
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-11439-03
ipv6 mfib hardware-switching
mls rate-limit multicast ipv6 (see
show ipv6 mfib
show mls rate-limit (see
Chapter 33, "Configuring Denial of Service
show platform software ipv6-multicast
show tcam interface
Verifying MFIB Clients, page 24-4
Displaying the Switching Capability, page 24-4
Verifying the (S,G) Forwarding Capability, page 24-4
Verifying the (*,G) Forwarding Capability, page 24-5
Verifying the Subnet Entry Support Status, page 24-5
Verifying the Current Replication Mode, page 24-5
Displaying the Replication Mode Auto Detection Status, page 24-5
Displaying the Replication Mode Capabilities, page 24-5
Displaying Subnet Entries, page 24-6
Displaying the IPv6 Multicast Summary, page 24-6
Displaying the NetFlow Hardware Forwarding Count, page 24-6
Displaying the FIB Hardware Bridging and Drop Counts, page 24-7
Displaying the Shared and Well-Known Hardware Adjacency Counters, page 24-7
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
New or Changed IPv6 Multicast Commands
Chapter 33, "Configuring Denial of Service
Purpose
Enables unicast routing on all Layer 3 interfaces.
Enables PIM-SM on all Layer 3 interfaces.
Enables MFIB hardware switching globally.
Protection")
Protection")
24-3