Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 53

Chapter 3 Configuring the Switch for the First Time
Enter the virtual terminal password when the following is displayed (remember this password for future
Step 6
reference):
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: bambam
Step 7 In most cases you will use IP routing. If so, you must also select an interior routing protocol, for
example, the Enhanced Interior Gateway Routing Protocol (EIGRP).
Enter yes (the default) or press Return to configure IP, and then select EIGRP:
Configure IP? [yes]:
Configure EIGRP routing? [yes]:
Your IGRP autonomous system number [1]: 301
Step 8 Enter yes or no to accept or refuse SNMP management:
Configure SNMP Network Management? [yes]:
Community string [public]:
For complete SNMP information and procedures, refer to these publications:
• Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.2, "Cisco IOS System
Management," "Configuring SNMP Support," at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/configfun/configuration/guide/fcf014.html
• Cisco IOS Configuration Fundamentals Configuration Command Reference, Release 12.2, at
this URL:
http://www.cisco.com/en/US/docs/ios/12_2/configfun/command/reference/ffun_r.html
To provide a review of what you have done, a display similar to the following appears and lists all of the
configuration parameters you selected in Steps
shown in the order in which they appeared on your console terminal:
The following configuration command script was created:
hostname router
enable secret 5 $1$S3Lx$uiTYg2UrFK1U0dgWdjvxw.
enable password lab
line vty 0 4
password lab
no snmp-server
!
ip routing eigrp 301
!
interface Vlan1
shutdown
no ip address
!
interface GigabitEthernet1/1
shutdown
no ip address
!
interface GigabitEthernet1/2
shutdown
no ip address
!
.
<...output truncated...>
OL-11439-03
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
3 through 8. These parameters and their defaults are
Configuring the Switch
3-7