Testtransceiverintegrity; Testnetflowinlinerewrite - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Software configuration guide
Hide thumbs Also See for WS-SUP32-GE-3B - Supervisor Engine 32:
Table of Contents

Advertisement

Appendix A
Online Diagnostic Tests
Table A-6
Recommendation
Default
Release
Corrective action
Hardware support

TestTransceiverIntegrity

The TestTransceiverIntegrity test is a security test performed on the transceiver during transceiver online
insertion and removal (OIR) or module bootup to make sure that the transceiver is supported.
Table A-7
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support

TestNetflowInlineRewrite

The TestNetflowInlineRewrite test verifies the NetFlow lookup operation, the ACL permit and deny
functionality, and the inline rewrite capabilities of the port ASIC. The test packet will undergo a NetFlow
table lookup to obtain the rewrite information. The VLAN and the source and destination MAC
addresses are rewritten when the packet reaches the targeted port.
Table A-8
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
OL-11439-03
TestActiveToStandbyLoopback Test Attributes (continued)
Schedule during downtime.
Runs at bootup or after OIR.
12.2(18)ZY.
Error disable a port if the loopback test fails on the port. Reset
the supervisor engine if all of the ports fail.
Standby supervisor engine only.
TestTransceiverIntegrity Test Attributes
Description
Nondisruptive.
Not applicable.
This test runs by default during bootup or after a reset or OIR.
12.2(18)ZY.
Error disable the port.
All modules with transceivers.
TestNetflowInlineRewrite Test Attributes
Description
Disruptive for looped-back ports. Disruption is typically less
than one second. Duration of the disruption depends on
configuration of loopback port (for example, Spanning Tree
Protocol).
Schedule during downtime. Run this test during bootup only.
This test runs by default during bootup or after a reset or OIR.
12.2(18)ZY.
None. See the system message guide for more information.
All modules including supervisor engines.
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Per-Port Tests
A-5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst supervisor engine 32 pisa

Table of Contents