Command-Line Interfaces
This chapter describes the command-line interfaces (CLIs) you use to configure the Catalyst 6500 series
switches.
For complete syntax and usage information for the commands used in this chapter, see these
Note
publications:
•
•
This chapter consists of these sections:
•
•
•
•
•
•
•
Accessing the CLI
These sections describe accessing the CLI:
•
•
OL-11439-03
The Catalyst Supervisor Engine 32 PISA Cisco IOS Command Reference, Release 12.2ZY, at
this URL:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2ZY/command/reference/cmdr
ef.html
The Release 12.2 publications at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_installation_and_configuratio
n_guides_list.html
Accessing the CLI, page 2-1
Performing Command Line Processing, page 2-3
Performing History Substitution, page 2-3
Cisco IOS Command Modes, page 2-4
Displaying a List of Cisco IOS Commands and Syntax, page 2-5
Securing the CLI, page 2-6
ROM-Monitor Command-Line Interface, page 2-7
Accessing the CLI through the EIA/TIA-232 Console Interface, page 2-2
Accessing the CLI through Telnet, page 2-2
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
2
C H A P T E R
2-1