Table of Contents
Advertisement
Chapter 15
Configuring IEEE 802.1Q Tunneling
To configure the switch to tag traffic in the native VLAN, perform this task:
Command
Step 1
Router(config)# vlan dot1q tag native
Router(config)# no vlan dot1q tag native
Step 2
Router(config)# end
Step 3
Router# show vlan dot1q tag native
This example shows how to configure the switch to tag native VLAN traffic and verify the configuration:
Router# configure terminal
Router(config)# vlan dot1q tag native
Router(config)# end
Router# show vlan dot1q tag native
OL-11439-03
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Purpose
Configures the switch to tag native VLAN traffic.
Clears the configuration.
Exits configuration mode.
Verifies the configuration.
Configuring 802.1Q Tunneling
15-7
- Quick Links:
- Product Overview
Hide quick links:
Advertisement
Table of Contents
Related Manuals for Cisco WS-SUP32-GE-3B - Supervisor Engine 32
Related Products for Cisco WS-SUP32-GE-3B - Supervisor Engine 32
- Cisco WAN Modeling Tools
- Cisco WS-SUP720-3B - Supervisor Engine 720
- Cisco WS-SVC-AGM-1-K9= - Anomaly Guard Module
- Cisco WS-SVC-CMM-ACT-RF - Conferencing And Transcoding Port Adapter Voice DSP Module
- Cisco WS-SVC-ADM-1-K9= - Traffic Anomaly Detector Module
- Cisco WS-SVC-FWM-1-K9= - Firewall Service Module
- Cisco WS-SVC-IDS2-BUN-K9 - Intrusion Detection Sys Module 2
- Cisco WS-SVC-IPSEC-1= - IPSec VPN Services Module