Configuring Health-Monitoring Diagnostics - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Chapter 51 Configuring Online Diagnostics
To schedule online diagnostics, perform this task:
Command
Router(config)# diagnostic schedule {module num} test
{test_id | test_id_range | all}
num_range | all}] {on mm dd yyyy hh:mm} | {daily
hh:mm} | {weekly day_of_week hh:mm}
This example shows how to schedule diagnostic testing on a specific date and time for a specific module and
port:
Router(config)# diagnostic schedule module 1 test 1,2,5-9 port 3 on january 3 2003 23:32
Router(config)#
This example shows how to schedule diagnostic testing to occur daily at a certain time for a specific port
and module:
Router(config)# diagnostic schedule module 1 test 1,2,5-9 port 3 daily 12:34
Router(config)#
This example shows how to schedule diagnostic testing to occur weekly on a certain day for a specific port
and module:
Router(config)# diagnostic schedule module 1 test 1,2,5-9 port 3 weekly friday 09:23
Router(config)#

Configuring Health-Monitoring Diagnostics

You can configure health-monitoring diagnostic testing on specified modules while the switch is
connected to a live network. You can configure the execution interval for each health-monitoring test,
whether or not to generate a system message upon test failure, or to enable or disable an individual test.
Use the no form of this command to disable testing.
To configure health-monitoring diagnostic testing, perform this task:
Command
Step 1
Router(config)# diagnostic monitor interval
{module num} test {test_id | test_id_range | all}
[hour hh] [min mm] [second ss] [millisec ms] [day
day]
Step 2
Router(config)#[no] diagnostic monitor {module
num} test {test_id | test_id_range | all}
This example shows how to configure the specified test to run every two minutes:
Router(config)# diagnostic monitor interval module 1 test 1 min 2
Router(config)#
This example shows how to run the test on the specified module if health monitoring has not previously
been enabled:
Router(config)# diagnostic monitor module 1 test 1
OL-11439-03
Purpose
Schedules on-demand diagnostic tests for a specific date and
[port {num |
time, how many times to run (iterations), and what action to
take when errors are found.
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Purpose
Configures the health-monitoring interval of the specified
tests for the specified module. The no form of this
command will change the interval to the default interval,
or zero.
Enables or disables health-monitoring diagnostic tests.
Configuring Online Diagnostics
51-5