Configuring Ipv6 Multicast Pfc3B Layer 3 Switching; Features That Support Ipv6 Multicast - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Configuring IPv6 Multicast PFC3B Layer 3
Switching
The PFC3B provides hardware support for IPv6 multicast traffic. Use these publications to configure
IPv6 multicast on Catalyst 6500 series switches:
•
•
These sections provide additional information about IPv6 multicast support on Catalyst 6500 series
switches:
•
•
•
•
•

Features that Support IPv6 Multicast

These features support IPv6 multicast:
•
•
•
•
OL-11439-03
The Cisco IOS IPv6 Configuration Guide, "Implementing IPv6 Multicast":
http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-multicast.html#Implementing_
IPv6_Multicast
The Cisco IOS IPv6 Command Reference:
http://www.cisco.com/en/US/docs/ios/ipv6/command/reference/ipv6_book.html
Features that Support IPv6 Multicast, page 24-1
IPv6 Multicast Guidelines and Restrictions, page 24-2
New or Changed IPv6 Multicast Commands, page 24-3
Configuring IPv6 Multicast Layer 3 Switching, page 24-3
Using show Commands to Verify IPv6 Multicast Layer 3 Switching, page 24-3
RPR redundancy mode—See
Multicast Listener Discovery version 2 (MLDv2) snooping—See
Snooping for IPv6 Multicast Traffic."
MLDv1 snooping is not supported.
Note
IPv6 Multicast rate limiters—See
IPv6 Multicast: Bootstrap Router (BSR)—See the BSR information in the
Configuration Guide and Cisco IOS IPv6 Command
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
C H A P T E R
Chapter 6, "Configuring RPR Supervisor Engine Redundancy."
Chapter 33, "Configuring Denial of Service Protection."
Reference.
24
Chapter 26, "Configuring MLDv2
Cisco IOS IPv6
24-1