Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 632

Common QoS Scenarios
To assign traffic to these queues, you need to configure a mapping of priority values to queues. QoS uses
the DSCP-to-CoS map to map the 64 possible outgoing DSCP values to the eight possible 802.1p values,
and then uses a CoS-to-queue map to map the CoS values to queues.
When the packet enters the switch, QoS is either configured to classify and mark the packet with a
configured DSCP value (as in the
section on page
Priority Value on Interswitch Links" section on page
priority as it leaves the switch.
This example shows how to display the DSCP-to-CoS mapping:
Router# show mls qos maps dscp-cos
Dscp-cos map:
Router#
The example marked the voice traffic with a DSCP value of 46. You can use the command output to
translate DSCP 46 to CoS 5. You can use the command output to translate the other marked DSCP values
to CoS values.
You can make changes to this mapping table to suit the needs of your particular network. Only minor
changes are typically necessary; this example does not make any changes.
For queueing purposes, the configuration derives a CoS value from the outgoing DSCP value. This CoS
value is used for queue assignment even if the outgoing port is an access port (that is, not a trunk port).
However, there will be no 802.1q VLAN tag transmitted on the network if the outgoing port is an access
port.
Map each derived CoS value to the queue structure. This example shows how to display the default
CoS-to-queue mapping, which shows the queue to which each of the eight CoS values is mapped:
Router# show queueing interface gigabitethernet 5/1 | begin cos-map
queue thresh cos-map
---------------------------------------
1
1
1
1
1
1
1
1
2
2
2
2
2
2
2
2
3
3
3
3
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
38-98
38-93) or to trust the packet's incoming DSCP value (as in the
d1 : d2 0 1 2 3 4
-------------------------------------
0 : 00 00 00 00 00 00 00 00 01 01
1 : 01 01 01 01 01 01 02 02 02 02
2 : 02 02 02 02 03 03 03 03 03 03
3 : 03 03 04 04 04 04 04 04 04 04
4 : 05 05 05 05 05 05 05 05 06 06
5 : 06 06 06 06 06 06 07 07 07 07
6 : 07 07 07 07
1 0
2 1
3
4
5
6
7
8
1 2
2 3 4
3
4
5
6
7
8
1 6 7
2
3
4
"Classifying Traffic from PCs and IP Phones in the Access Layer"
38-96). These options determine the packet's
(dscp= d1d2)
5 6 7 8 9
Chapter 38 Configuring PFC QoS
"Accepting the Traffic
OL-11439-03