Configuring Eigrp Nsf; Verifying Eigrp Nsf - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

NSF Configuration Tasks

Configuring EIGRP NSF

To configure EIGRP NSF, perform this task:
Command
Step 1
Router# configure terminal
Step 2
Router(config)# router eigrp as-number
Step 3
Router(config-router)# nsf

Verifying EIGRP NSF

To verify EIGRP NSF, you must check that the NSF function is configured on the SSO-enabled
networking device. To verify EIGRP NSF, follow these steps:
Verify that "nsf" appears in the EIGRP configuration of the SSO-enabled device by entering the show
Step 1
running-config command:
Router# show running-config
.
.
.
router eigrp 100
auto-summary
nsf
.
.
.
Enter the show ip protocols command to verify that NSF is enabled on the device:
Step 2
Router# show ip protocols
*** IP Routing is NSF aware ***
Routing Protocol is "eigrp 100"
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Default networks flagged in outgoing updates
Default networks accepted from incoming updates
EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
EIGRP maximum hopcount 100
EIGRP maximum metric variance 1
Redistributing: eigrp 100
EIGRP NSF-aware route hold timer is 240s
EIGRP NSF enabled
Automatic network summarization is in effect
Maximum path: 4
Routing for Networks:
Routing Information Sources:
Distance: internal 90 external 170
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
5-18
NSF signal timer is 20s
NSF converge timer is 120s
Gateway Distance
Chapter 5 Configuring NSF with SSO Supervisor Engine Redundancy
Purpose
Enters global configuration mode.
Enables an EIGRP routing process, which places
the router in router configuration mode.
Enables EIGRP NSF.
Use this command on the restarting router and all
of its peers.
Last Update
OL-11439-03